The RAM® EZ-Roll’r™ cradle for the iPad Pro 11” secures your device in a form-fit holder while keeping the entire screen visible. Simply slide your iPad into the cradle and roll the top clip over the device to secure into place. The side buttons, camera, and charging port are conveniently exposed and accessible. This RAM® EZ-Roll’r™ cradle also features three attachment points on the back to attach a RAM® round ball base. An attachment point on the side of the cradle allows for the placement and removal of the Apple Pencil. |
Perfect for what I needed. Loved the mounting position options on the back
RAM Ez-RollR Cradle For Apple iPad Pro 11-Inch / Air 4 / Air 5
RAM Ez-RollR Cradle For Apple iPad Pro 11-Inch / Air 4 / Air 5
RAM Ez-RollR Cradle For Apple iPad Pro 11-Inch / Air 4 / Air 5
Bon service et fonctionne tres bien.
Do not work with the latest version of the Ipad Pro 11po. The latest version (M4) is 249.7 mm height while all the previous version (4th, 3rd, 2nd and original) were all 247.6 mm.
Fits well and securely. you can only put the ipad in one way (due to contact on the power button). I have to install the ipad upside down to fit properly in front of the yoke and then the charger comes off the top which can be annoying. Fine in cruise and then i remove the cord for landing.
RAM Ez-RollR Cradle For Apple iPad Pro 11-Inch / Air 4 / Air 5
For the iPad pro and iPad air 8th generation, but a tight fit for my iPad Air. The shipping was as much as the item, It could have been shipped in a much smaller box or bubble envelope and saved us both and the environment some cost...
DEVICE WORKS WELL, BUT IT TOOK FOREVER TO GET HERE.
Case fits very tight on my new iPad Air
RAM Ez-RollR Cradle For Apple iPad Pro 11-Inch / Air 4 / Air 5
Fit is not good for my new Air 5. Top hook too short. Attaching hardware not same quality as old one
RAM Ez-RollR Cradle For Apple iPad Pro 11-Inch / Air 4 / Air 5
Please note, Aircraft Spruce Canada's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Canada assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
No, Part# 11-07069 must be ordered separately.
Yes, this will work with the iPad Pro 11, 3rd Gen.
This cradle is the correct cradle for iPad model 2324. For the iPhone 11 suction mount, you would want to order qty 1 of the following: qty 1 x 11-19008, qty 1 x 11-00471, qty 1 x 11-03458, qty 1 x 11-02081.
Yes, this is compatible with the new iPad Air 5.
Yes, this cradle fits the iPad Air 5 (2022).
Yes, this cradle fits the Air 5.
Yes, this will fit the iPad 10 10.9 inch.
7-1/4 width and 9-5/8 height