FREE SHIPPING ON ORDERS OVER $699 (SOME EXCLUSIONS APPLY) | 877-795-2278

Hylomar Medium Gasket Maker - 3.52oz

$97.80/Each
Quantity
Add to Wishlist
Part# 04-03923
MFR Model# PL32-40ZMED

Overview

Hylomar Aerograde is a highly engineered, non-setting and non-hardening gasketing compound for use in the aeronautical industry with a wide operating temperature of -50°C to +250°C. Hylomar Aerograde was developed in conjunction with Rolls Royce – Aerospace Division for sealing joints in turbine engines. Hylomar Aerograde is resistant to:
  • Air, water and oils
  • Turbine and piston engine combustion products
  • Water/glycol and methanol/water mixtures
  • Petroleum and synthetic diester lubricating oils

Features

  • Non-hardening and non-setting
  • Resistant to air, water and oils
  • Specified worldwide by OEM’s
  • Wide operating temperatures (- 50°C to +250°C)
  • Easy to use
  • Unlimited assembly time
  • Easy to disassemble components
  • For use on metal and plastic close fitting components
  • Use as a non-curing thread sealant
  • Resists vibration
  • Easy to apply to vertical and underside joints due to its thixotropic properties
  • Can be used with or without a gasket

Specifications

  • Film Thickness: 0.03 mm
  • Typical Surface Finish: 3.0 μm Ra
  • Area covered by 100g: 1.125m²
  • Product coverage after drying: 4mg/cm²

Documents

  • Frequently Purchased With
  • Customers Also Viewed

Reviews

Q&A

Please note, Aircraft Spruce Canada's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Canada assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.