Just as described. Fixed my problem.

Mike J Verified Purchase

J.P. Instruments EDM Press Fuel Flow Transducer Floscan 201

Purchased to replace an identical unit that failed in less than 3 years and 100 hours of use.. New one works perfectly but definitely don’t consider it a good value.

Commemorative A Verified Purchase

J.P. Instruments EDM Press Fuel Flow Transducer Floscan 201

I own a Piper PA-32-301 that currently as the 700 in it, I would like to upgrade to the 730 and add fuel monitoring to it, can you please tell me what I need to purchase for this upgrade, Thanks

Fast, friendly, prompt service on ordering, good tracking info, exactly what I needed.

Mark S Verified Purchase

J.P. Instruments EDM Press Fuel Flow Transducer Floscan 201

Exact replacement and very good quality

Mike B Verified Purchase

J.P. Instruments EDM Press Fuel Flow Transducer Floscan 201

I should have specified K factor as 30.02. Product description did not tell me to do so.

Thomas A Verified Purchase

J.P. Instruments EDM Press Fuel Flow Transducer Floscan 201

Works as advertised

Dan L Verified Purchase

J.P. Instruments EDM Press Fuel Flow Transducer Floscan 201

No issues. Transducer replaced on that I bought new in September 2018 and died on a flight a few weeks ago. Installation was simple, reset the ‘K’ factor and worked perfectly on last trip to Virginia and back. Very accurate. Drives a JPI EDM 730.

The preinstalled wire connecting is too short!! It should be approximately 3 feet long to keep the connector away from hot & oilly engine compartments .

The FF Transducer is fine, the “3” rating is for the nickel and diming JPI did for this addition. For the amount that this harness is worth, they could’ve included it with the transducer. After getting this fuel flow transducer, I looked at the installation instructions (not well written) and figured out that you also need a JPI Fuel Flow Harness (10-04650) that plugs into P4 for ANOTHER $185. But, in the manual, the drawing shows the wiring diagram. You’ll need a DAMA15P 15 pin connector and backshell and a C&K 7103 mini toggle switch. About $20 worth of parts. Build it yourself.

Product documentation for this flow meter is poor. Contradictory statements are made, and no specification is provided for the thread types. The manufacturer suggests not using thread sealant, but NPT threads are not self-selaing - they will produce a spiral leak along the OD of the threads if no sealant is applied. This would not be the case if the threads were cut to NPTF standards, but again, the thread cut specified in the documentation said it was a 1/4 NPT. No sealant on NPT threads will result in a spiral leak.

Ali S Verified Purchase

J.P. Instruments EDM Press Fuel Flow Transducer Floscan 201