FREE SHIPPING ON ORDERS OVER $699 (SOME EXCLUSIONS APPLY) | 877-795-2278
Thumbs 1
Thumbs 1

MGL Westach Oil Temp Sender 5/8-18 Unf Thread (Lycoming And Control)

$114.75/Each
Quantity
Add to Wishlist
Part# 11-16730
MFR Model# 399S9

Overview

The Westach Oil Temperature Sender can be used to help if you are experiencing problems or if you suspect your oil temp sender is reading incorrectly. This item is the oil temperature sender typically used on the Lycoming engine.

Features

  • Screw in 5/8-18 UNF Threaded Westach Oil Temp sender as shown, with crush washer
  • Use adapter fitting if required
  • Sender has 2 black wires (interchangeable) – connect one wire to Oil Temp input and the other to RDAC Ground
  • Note that EFIS will read 32 deg F (0 deg C) until you reach operating temp of 70 deg F
  • Frequently Purchased With
  • Customers Also Viewed

Reviews

Looks good

Larry R Verified Purchase

MGL Westach Oil Temperature Sender 5/8-18 Unf Thread (Lyc./Cont.)

April 16, 2023

When my Dynon oil temperature sender failed (temperature indications fluctuated wildly, WAY into the red), Dynon blamed my engine ground. I couldnt find anything wrong there, so I replaced the oil sender with this two-wire unit. Problem solved -- My oil temperature needle is now rock steady, and apparently accurate.

Brooks W Verified Purchase

MGL Westach Oil Temperature Sender 5/8-18 Unf Thread (Lyc./Cont.)

June 24, 2021

Q&A

Please note, Aircraft Spruce Canada's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Canada assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.

Q: Will this work with a VDO temp gauge part number 10-01579?

No. The sensor is not known to be compatible with this gauge.