These switches are used with the Westach CHT, EGT, or CHT/EGT gauges to allow multiple cylinder engine analyzing. Switches included with Engine Analyzer kits & Add-On kits on following pages, or can order separately below. Non-TSO’d. These switches have two small connectors of same size.
Made in USA |
Exactly what I was hoping for. Easy to install with clear instructions.
Westach 4 Position Switch With 8 Lead 254-4F Non-TSO
Just as ordered
Westach 4 Position Switch With 8 Lead 254-4F Non-TSO
WORKS as advertised good value
This switch works well, and the cable is just the right length for a Long EZ. However, the switch is relatively inexpensive, and only seems to last about 3 years before needing replacement.
Please note, Aircraft Spruce Canada's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Canada assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
The Westach Engine Analyzer Kit includes Part numbers 10-01241, 10-01244 and 10-01225. These are non-TSO'd and are not approved for certified aircraft.
It is the switch plus 3 probes.
Hole size is .370". Switch plate diameter is 1.75". Switch body is 1.1" diameter. Threaded shaft is about 1/4" long
This has a push on pin/socket style connectors.