SAME DAY SHIPPING ON ORDERS PLACED BY 2 PM | 877-795-2278

Fuel Probe 12/24V 6 In 0-5V

$226.95/Each
Part# 10-03753
MFR Model# FP1206V

Overview

The probe is constructed of concentric tubing (a small tube inside a larger tube). The tubes, which are separated by small insulators to keep the tubes from touching, acts as a capacitor that has one value in air (empty tank) and changes in value as the fuel level rises inside the probe. The amplifier converts these values to a signal suitable to drive a standard meter or other display device. Can be manually calibrated. See Documents tab.
12-24 Volts
6,12, or 24 inches

Reviews

Q&A

Please note, Aircraft Spruce Canada's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Canada assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.

Q: Will this fuel probe fit the hole pattern for a normal float type sensor? Can this be shortened this 24" to 17"?

This probe has a standard SAE 5-hole bolt pattern, which most float type sensors have. Yes, it can be shortened down to half its length, so 17" would be no problem.

Q: What is the height of the top part of the sender above the seal? I have 3/4 inch of room between the sender seat and the cover panel on the wing.

The top part of the sender above the seal has approximate height of 11/16".

Q: What is the diameter of the top part?

2.6 inches

Q: Can this probe be mounted on the bottom of the tank?

Yes, part # 10-03753 can be mounted to the bottom of the tank.

View in Catalog

View Image View in Catalog