All-steel construction, adjustable set holder (accepts all sets with 3/16” shank), and long handles for increased force. Yoke is made of the highest quality tool steel. By simply removing 3 pins you can change the yoke to match your riveting or dimpling application. The squeezer includes the yoke of the coordinating size. |
Works very well for nut plates in tight spaces and squeezing rivets on edges of wings or trailing edges
Economy Hand Rivet Squeezer 1 With Yoke
I have used the 1 oke Econ quite a bit. The position of the rivets I need to squeeze are always within 1/2 inch of trailing edge so this tool is ideal.
Economy Hand Rivet Squeezer 1 With Yoke
Nice to have 1 and 2 yokes to be able to rivet in the occasional tight/hard to reach spots
Economy Hand Rivet Squeezer 1 With Yoke
This rivet squeezer is EXACTLY what I needed.
Economy Hand Rivet Squeezer 1 With Yoke
Quality tool, made in taiwan. Bought together with additional 3 yoke and 17pcs squeezer set assortment.
Economy Hand Rivet Squeezer 1 With Yoke
I needed an economical squeezer to dimple a small amount of holes on a RANS S-21 build. I didnt want to spend big money since there are only a few flush rivets on that kit. This is a simple design and sturdier than I expected. It got the job done quickly and precisely. I would buy again.
Item was just what I needed for my project, I had a question about adjustment before I bought. Got the answer and purchased the squeezer.
Great product and company experience. Delivered quickly.
Great product and delivered reasonably quick. Great company.
On time, worked as promoted. Well built and a very good value.
Please note, Aircraft Spruce Canada's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Canada assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Yes, this would come with the 2" yoke.
The 12-01460 is sold with a 1" yoke included. It has a 1" depth clearance.
The ram that holds one of the sets rotates to adjust the set up or down. New units may be a little stiff, and require a small pin, or nail, to make the first few turns.
Yes, it will accept a die.
The gap is roughly 1-1/4 so with the sets approx 3/4 long.