Aircraft Spruce Canada
Brantford, ON Canada
Corona, CA | Peachtree City, GA
Chicago, IL | Wasilla, AK
Aircraft Spruce Canada- Wishlists
- 1-877-795-2278
- Contact Us
Contact Us
Call Us
Sign In
- Photo may represent series and not specific product
- SHARE
Aws Ball Bearing Frame 13
MFR Model# AWCFB13
- JUMP TO
- Overview
- Reviews
- Q&A
- View in Catalog
Overview
| The ball bearing windsock frames are a rugged design constructed of a welded steel construction and then a powder coated finish for corrosion protection. They incorporate a two bearing pivoting design for effortless pivoting. These frames are ready to be mounted on a 3/4” female pipe thread for the 8”, 13”, 18” and 24” and a 1” pipe thread for the 36”. |
Reviews
product is very good quality as advertised
Verified Purchase
Aws Ball Bearing Frame 13
Was easy to install sock and works great :)
Verified Purchase
Aws Ball Bearing Frame 13
Very high quality and light weight. It screws onto a 3/4” pipe. The ball bearings allow the sock to respond to the slightest wind.
Verified Purchase
Aws Ball Bearing Frame 13
Very satisfied with this product.
Well built and easy to install, we mounted it on top of a carbon fiber pole on the roof of our sun-shelter. We are a RC Flying club. www.wimca.ca
The frame spins easily and is sensitive to the wind. It is well made. It arrived undamaged, was well packaged and in good time. It was a couple of days later than estimated, but it was ordered over Christmas.
Solid construction, should last a long time. Bearings make it swivel so easily! Well worth the $.
Looks great and can not wait to get it up!
Bought this for my dad, he loved it. Storm blew it away and Im buying him another one!
After a quick nspecting the Ball Bearing Windsock Frames upon receiving it I found the rubber top cap is possibly truly the weakest link for this other than that, seeming great product. When the rubber cap fails it will expose the bearings to eventually leading to bearing failure. I plan to correct this for problem prior to its failure. Other than that, prior to installation this product looked to be well constructed. The wire ties were of poor quality and no extras ones included. The welded structure itself looked to be made well and powder coated.
Q&A
Please note, Aircraft Spruce Canada's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Canada assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Yes, it would work with standard 3/4" plumbing fittings.
FAA type L-806 support - those mounted on low mass supporting structures - maximum of 3.0 m (10 ft) mast height. brbr FAA type L-807 support - those mounted on rigid supporting structures - Maximum of 4.8 m (16 ft) height to windsock.
Unfortunately we do not offer any custom embroidery on these wind socks. We only sell them stock, it would need to be embroidered post receipt.
