Insight is the world's largest manufacturer of aviation temperature probes. The temperature probe measures the engine's pulse and therefore is crucial to optimum performance. Insight's probes are built and tested to the highest quality control standards to ensure long life and high performance. The EGT probe consists of a special alloy sheath connected to a stainless steel clamp. The probe tip is installed in a small hole in the exhaust stack, secured by an adjustable clamp. |
Great product. Engine monitors are great for monitoring engine performance.
Insight EGT Probe # 2870
Install easy problem fixed
Insight EGT Probe # 2870
5 stars
Insight EGT Probe # 2870
Product arrived quickly and worked as it should.
Insight EGT Probe # 2870
Product works great
Insight EGT Probe # 2870
Product good but if you remove after a time in service They sometimes fail after reinstall
Insight EGT Probe # 2870
Worked. Lead same length as old one being replaced.
Insight EGT Probe # 2870
Exact fit and works pefectly
Promptly shipped and delivered earlier than the tracking system indicated. So far, it is working just fine.
Delivered fast, worked perfect. 8130 was included.
Please note, Aircraft Spruce Canada's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Canada assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Yes, the Gem EGT probe (2870) will work with your Lycoming IO320 a1b.
Yes, this is a grounded probe which can be tested with an ohm meter. The resistance between the two leads should be less than 2 ohms.
Per the manufacturer, this clamp fits 1-5/16"(inch) to 2-1/4" pipe.
Probe is 1/8 inch inside the clamp.
Yes, all the 2870 probes are the same length.