Material | Engine | Part No. |
---|---|---|
Mild Steel | Lycoming 0-235 to 0-540 | 33021 |
I thought these were laser cut. They were punched out which distorts the flatness and leaves pulled and smeared metal that may need grinding away to fit tubing. Then then it takes more sanding on a large belt sander to get flanges flat and parallel.
Poor quality mild steel flange. Not flat. Unfinished. Burrs and sharp edges.
Mild Steel Exh Flange # 33021
Please note, Aircraft Spruce Canada's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Canada assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
P/N# 33021 Is a 1018 Mild Steel. P/N# 33102 is a 321 Stainless Steel.
Yes, that is correct.
They are both about a 1/4" thick.
The center hole is 1-1/2".
1-3/4"