Tube Dia. | Dash No. DG | Dash No. WDG |
---|---|---|
1-3/8 | MS21919-DG22 | WDG22 |
Loop-type cushioned aluminum alloy clamp. Cushion (non-fuel resistant) is bonded to inner surface and edges of clamp. WDG clamps are cushion wedge type. Cushion assures tight fit and eliminates vibration, thus preventing line abrasion. Note: Revision E only applies to WDG clamps. See Tech Data Sheet. |
G reat clamps at a great price. Was not used for aviation purposes, but worked for what I needed it for.
Clamps MS21919-DG22
great
As Advertised
Quick shipping and parts were correct.
Friendly staff and great service.
the right part at a good price
the right part at a good price
Works as advertised.
These are the good kind. You have to open them wide when installing so the “wedge” goes all the way around the ‘tube’ and protects the entire circumference. Size is in 16ths of inch, so size 8 is half inch. Get the tool for installing, very difficult without.
They worked great!
Please note, Aircraft Spruce Canada's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Canada assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
WDG clamps are cushion wedge type clamps. You can see this wedge clearly by looking at the third image (far right) on this web page.
The diameter tolerance of the mounting holes is .199 through .209 which would require a #10 screw or AN3 bolt. All clamps listed on this web page have the same size mounting holes.
Part number 12-02017 is designed to aid in the install of these clamps.