This flap handle is a well built, durable, and cost effective alternative to the plain round standard flap toggle switch that exists in most experimental aircraft. This unit is easily installed over the existing toggle switch with the included set screws. This unit is powder coated for a long lasting, durable finish.
Note: This is the Flap Handle Only |
Impressive,Very high quality, Looks factory and really helped with night flying , I can just feel it to find flap control.
Flap Handle
Flap Handle
Bought this for my RV7A, as others have said this is not plastic and is a single piece ( not two sides screwed together) of powder coated metal. Should last forever Slid over existing toggle switch perfectly. When installing, tighten one side until it touches toggle, then the other, then fully tighten both sides to ensure its secure and even. Does not slip or turn at all. Makes touch and goes much safer as flaps are much easier to find and use without having to look. Best $40 Ive spent in a while.
Flap Handle
Perfect
Flap Handle
Well made, easy to install, works perfectly as advertised. Verify that you have the correct size hex key or Allen key to install to avoid a second trip to the airport... -)
Flap Handle
Great as usual
Slightly over priced but functions perfectly. I even talked my neighbor into getting one for his plane too. All I had before was the normal toggle switch which is very slippery and I can only imagine will be hard to operate in anything other than perfect flying weather. I would definitely recommend this to anyone that has a toggle switch for their flaps.
Well made, should work well in my RV 4
Excellent product I highly recommend to all builders/ owners. Genuinely great design, machining, and finish.
Nice product, well made and fit perfectly
Please note, Aircraft Spruce Canada's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Canada assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
The flap handle mounting hole diameter is about .245 in diameter to fit a standard size toggle.
3/4 inch width.
It would fit but it would rotate with the switch.
This part is just the non-rotating handle that can be added to a traditional toggle switch.
We do not have anything that matches this spec.