THE AVIATION SUPERSTORE FOR ALL YOUR AIRCRAFT & PILOT NEEDS | 877-795-2278

BendixKing Heated 12VDC Probe For King KLR 10

$571.00/Each
Quantity
Add to Wishlist
Part# 11-12024
MFR Model# 89000008-543001

Overview

12 VDC Heated Probe for the KLR 10 unit.

This optional heated probe requires less than 8 AMP of electrical power at 12VDC. Determine the size of wire required from AC43.13-1B Chapter 11 Section 5 (For 12VDC in free air, #14 wire will be adequate for runs up to 20 ft. As an added precaution to prevent interference with other aircraft systems, use MIL-SPEC. shielded wire. Electrical cable/wire must be installed such that the risk of mechanical damage and/or damage caused by fluids, vapors, or sources of heat, is minimized. Route as far away as possible from any instrument, system or wiring that may be affected (i.e. compass/flux gate, antenna or antenna coax). It is recommended that you use a MIL-SPEC. DC switch with silver contacts rated for twice the required amperage.

Reviews

Q&A

Please note, Aircraft Spruce Canada's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Canada assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.

View in Catalog

View Image View in Catalog