Otto Controls has been making the switches used in a majority of military and commercial flight grips manufactured for the last 40 years. Otto has evolved from a switch supplier into a major gri supplier with flight grips in numerous military and commercial aircraft. These rugged grips are the same as our military qualified grips but without the expensive threaded connector. Grips have a 1.15"ID which can be adapted to a 3/4" or 7/8" joystick with separate sleeves sold below.
Note: Made in accordance with MIL-DTL-25561. |
Used to replace the existing Bell 206 cyclic grip. Easy installation with a great assortment of electrical switches for accessory operation.
Please note, Aircraft Spruce Canada's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Canada assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Per the manufacturer, there is no left hand version available.
Yes, the trigger switch on grip 11-00751 is a double detent.
Yes, all switches and trim hat are included.
There is no wiring coming out the bottom of the grip. The buttons / triggers have terminals that will need to be wired into the aircraft. Wire must be purchased separately.
It is normally open.
It comes with the buttons, switches, and hardware.