Soldering Sleeve 1/4" LC-3.
Termination sleeves consist of a heat-shrinkable, transparent, polyvinylidene fluoride sleeve with an inner, pre-fluxed, solder preform and two thermoplastic sealing inserts. When heat is applied, the solder melts and flows to provide a superior connection between the ground lead and the shield. At the same time, the two thermoplastic sealing inserts melt and the outer sleeve shrinks to provide an environmentally protected termination. Otherwise, they are essentially the same. |
Sumitomo Soldering Sleeve L-C-3 .250
Sumitomo Soldering Sleeve L-C-3 .250
These work great for shield grounds and are much cheaper than Raychem.
Sumitomo Soldering Sleeve L-C-3 .250
Best enviro sleeve available
Sumitomo Soldering Sleeve L-C-3 .250
Please note, Aircraft Spruce Canada's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Canada assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Recommended heated temperature per the manufacturer is 125 degrees celsius.