Manifold pressure is one factor used to obtain correct power setting of the engine. The indicators are temp. and altitude compensated. Matte-white dials. 2-1/4" units are new mfg. 10"-50" Hg. Interchangeable with AN5770-1. |
Easy to install and works great. The instructions are a little hard to follow. Suffice it to say that this unit assumes the ambient temperature is 75 degrees and will display a cht that starts there. So, if the ambient temp is less than 75 degrees the unit is assuming its hotter than it really is. So, you subtract one degree for each degree below 75. If its hotter than 75, the unit assumes its cooler than reality, so you add one degree for each ambient degree above 75.
UMA 2-1/4 Mechanical Manifold Pressure 10 - 35 In Hg Non-TSO
Lasted about 2 hours, then stuck at 25. Returned for replacement. Another one I have has been working fine for ~ 5 yrs.
Please note, Aircraft Spruce Canada's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Canada assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Per the supplier: "these are mechanical, so there are no additional senders or accessories required for installation."
Per the supplier: "these are mechanical, so there are no additional senders or accessories required for installation."
No, this unit is not FAA Approved.
Per the installation instructions, only the V port is being used.