Superior to any other type of pyrometer available. Unlike competing brands, these units are temperature compensated. That is, when the ambient temp. changes, MIRCO-1000 pyrometers still read the same. And we guarantee that, when properly installed, these pyrometers will be accurate within 2%. Like other Micro1000 gauges, these units come with our standard 2-year warranty. Order gauges, probes, and extension leads separately. Scaled 0-600 F. |
The terminals on my Micro 1000 gauge end of the extension lead were crimped on incorrectly... i.e. the red negative wire had the terminal that only fit the positive gauge connection and, of course, the purple positive wire had the terminal that only fit the negative gauge connection. (one side is male, other side female). I had to snip off the incorrect terminals on the extension leads and crimp on the correct ones, I hooked them back up (in correct order) to the CHT gauge, and voila! the gauge worked. I still give this product 5 stars because of its quality and accuracy!
It is great to be able to afford a CHT gauge that is compensated for ambient temperature. Thank you for carrying it! Van Baehr
Initial installation instrument read 200 degrees in 60 degree hangar. Almost any heat applied to probe would send it off scale to high side. Returned instrument for evaluation. Two months later received instrument that seems to work. No idea if the replaced instrument or repaired the one we sent in.
Please note, Aircraft Spruce Canada's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Canada assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
You must order the probes for the micro 1000 CHT separately. They come in 10, 12, 14, and 18mm.
No, only the size and mounting design are different.
The 2-1/4" gauge is a standard 2-1/4" round bezel with the 2-5/16" square plate for mount in a round hole.
No, it does not come with the lead. You will need to purchase that separately. 10-01442 is a 7ft lead and 10-01443 is the 15 ft lead.
It will work fine in an aircraft without an electrical system.
These are not TSOd and the probe and extensions are type E.