This temperature probe, with 10 foot long cable, connects directly to the optional remote compass (only) to provide outside air temperature, true airspeed and density altitude. |
Easy install. Cut the third wire per instructions for my particular installation. Programed Dynon, works perfectly.
Dynon OAT Probe D180 D100 D60 D10A D6
Please note, Aircraft Spruce Canada's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Canada assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
The Dynon Avionics outside Air Temperature probe is designed to work with D10A the D100. Using this probe with another manufacturer’s product is not tested and not recommended.
The probe needs to contact to the EDC-D10A, which then will interface with the D100.
Yes, part # 10-01823 is Dynon model no. 100433-001.
Per the installation manual, it can be used, please refer to the manual to verify proper installation.
No, each system will require it's own probe.
Per the manual, you must use probe part # 11-04603.
This sensor is for experimental applications and it does not come with any installation hardware.
This has 4 wires.