THE AVIATION SUPERSTORE FOR ALL YOUR AIRCRAFT & PILOT NEEDS | 877-795-2278

Westach Manifold Pressure Gauge 2A4-6

$147.75/Each
Quantity
Add to Wishlist
Part# 10-04797
MFR Model# 2A4-6

Overview

Manifold Pressure 2-1/4", square, 0-30 in HG, pointer set at 29 IN HG, full sweep meter, Not altitude Compensated, w/ 220-9 Hose = 7' & two fittings 203-17 & 203-21.

Made in USA

Reviews

This instrument did not work at all for me, as it does not read actual manifold pressure, but only the difference between ambient pressure and manifold pressure. Before I installed it I took it with me on a flight in a pressurized aircraft. At 8000 cabin altitude it was reading (you guessed it) 30 of manifold pressure. The case is not sealed at all, and therefore all it is capable of measuring is differential.

Bruce C Verified Purchase

Westach 2-1/4 Square Manifold Pressure 0-30 In Hg 2A4-6 Non-TSO

April 21, 2023

Q&A

Please note, Aircraft Spruce Canada's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Canada assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.

Q: Is the 2.25" size the dimension of the square face or the diameter of the round face of the instrument?

It is the diameter of the round face of the instrument.

Q: what are the outside dimensions of gauge?

The outside dimensions are 2.25" L by 2.25" W.

Q: Does it use a electrical sender or a vacuum hose goes to the instrument?

It uses a vacuum hose.

Q: The diameter of the round face and the height and width of the gage cannot both be 2-1/4 inches. Would you please verify the dimension on this instrument? Does it fit in a standard 2-1/4 instrument hole?

The diameter of the face is 2-1/4". The height and width of the gauge is 2-13/32". Yes, it fits a standard 2-1/4 instrument hole.

View in Catalog

View Image View in Catalog