Designed to produce light 360° around the aircraft ±30° as required. Mount on top or bottom of fuselage or on vertical fin. Requires use of either H 102 or H 103 mounting adapters. Special three conductor shielded cable must be used between light assembly and power supply. MODEL A 470A Incorporates vibration proof flash tube (A 469B) which allows flush mounting. Available with Aviation Red, White or split Red/White optic lens. Specify voltage. MODEL A 450 White strobe light with clear Pyrex glass dome. recommended for installations subject to severe vibration, moisture and chemical conditions such as Ag aircraft. This system was designed in 1968 when only 100 candles output was required. An economical system for daylight operation. Specify voltage. |
Thanks for your email
Whelen parts are of high quality and affordable.
Good fit on the round gasket W1283.
Works great as mounted on top of the fuselage. I didnt catch the fact that I need a mounting plate and therefore had to pay shipping on a separate order...
Good quality part, well packed. Extremely high price for small gasket. Need second source for older Cessna parts.
Please note, Aircraft Spruce Canada's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Canada assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
The H102 adapter is used for flush mounting, and the H103 is used for mounting in a standard 3-3/4" rotating beacon hole.
Yes, these are FAA - PMA approved.
Yes, this is PMA approved.
It would require a power supply.
Per Whelen: The H102 can be removed. It is simply a means to "clamp" the legacy lights to the fin cap. The new LED beacons have a mounting base built in that has the same hole pattern as the anchor nuts in the vertical fin of the airplane = easy install. The 71055 will work. The 71080 Series will work (30% brighter) but a little taller. The 7108051 (Spruce p/n - 11-07686) assuming the aircraft is 14volt.