FREE SHIPPING ON ORDERS OVER $699 (SOME EXCLUSIONS APPLY) | 877-795-2278
Thumbs 1
Thumbs 1

Icom A220 Rear Panel Adapter

$133.85/Each
Quantity
Add to Wishlist
Part# 11-14470
MFR Model# MBA3

Overview

ICOM A220 MBA-3 Rear Panel Adapter. For installation into a card edge connector equipment including PS-80.

Reviews

Some tips on disconnecting and re-connecting the multi-wire connector would be helpful.

James K Verified Purchase

Icom MbA3 A220 Rear Panel Adapter

October 17, 2024

As advertised. Used for installation of A220 into A200 tray. Verify the pin out of the tray to the needs of the A220. There may be some extra connections on the A200 tray.

James S Verified Purchase

Icom MbA3 A220 Rear Panel Adapter

January 10, 2024

Does the job. Easy and no problems. New radio in older PS-80. Perfect

Robert M Verified Purchase

Icom MbA3 A220 Rear Panel Adapter

November 21, 2021

Q&A

Please note, Aircraft Spruce Canada's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Canada assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.

Q: Is this adapter plug n play? ie, just screw to the tray and good to go? Or is there some assembly/soldering required?

THE Icom MBA3 Rear Panel Adapter with card edge connector fits the Icom A220. The MBA3 allows A220 to fit into a panel mount previously occupied by King KY96A, KY97A, KY196A, KY197A.

Q: Will the MBA3 adaptor allow the Icom A220 fit in the A200 tray? And please answer the original question: Is this adapter plug n play? ie, just screw to the tray and good to go? Or is there some assembly/soldering required?

This MBA3 will require soldering and additional assembly. It is not plug and play. Per the manufacturer it will allow the unit to be retrofitted into the A200

Q: I would like to replace my old IC 210 E with IC A220. Do I have to use an adapter in order to install it into the old 210 docking receptacle?

The correct adapter needed will be an MBA-3/11-14470.

View in Catalog

View Image View in Catalog