This cutter centers around the filter quickly, with no parts to change, and you can cut the filter in either direction. Cuts all Champion® and Tempest® 3.7 diameter filters. Rugged 6061-T6 aluminum construction. Roller bearings provide smooth rolling action. Hardened hardware throughout. No parts to change and it can cut in either direction. There is a clearance hole for filters with a stud. Made in USA. Lifetime Warranty. Filter Not Included. |
Great value. Cuts quickly and easily.
Fc-2000 Oil Filter Can Cutter
works great
Fc-2000 Oil Filter Can Cutter
Easy to use, works great.
Fc-2000 Oil Filter Can Cutter
Fc-2000 Oil Filter Can Cutter
Fc-2000 Oil Filter Can Cutter
Good
Fc-2000 Oil Filter Can Cutter
Great product! Worked very well.
Fc-2000 Oil Filter Can Cutter
Quality made in USA. I recommend this tool to anyone.
Fc-2000 Oil Filter Can Cutter
It worker ok, it would be better if it was square then you could put it in a vice.
Fc-2000 Oil Filter Can Cutter
Works great
Fc-2000 Oil Filter Can Cutter
Please note, Aircraft Spruce Canada's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Canada assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Yes, this will work with all of the Champion filters.
This should work with all filters, the hole allows clearance for the stud on male filters.