Great value. Cuts quickly and easily.

Michael W Verified Purchase

Fc-2000 Oil Filter Can Cutter

works great

Howard F Verified Purchase

Fc-2000 Oil Filter Can Cutter

Easy to use, works great.

Cobert C Verified Purchase

Fc-2000 Oil Filter Can Cutter

Good

Eugene G Verified Purchase

Fc-2000 Oil Filter Can Cutter

Great product! Worked very well.

Rick R Verified Purchase

Fc-2000 Oil Filter Can Cutter

Quality made in USA. I recommend this tool to anyone.

Tim M Verified Purchase

Fc-2000 Oil Filter Can Cutter

It worker ok, it would be better if it was square then you could put it in a vice.

Sterling G Verified Purchase

Fc-2000 Oil Filter Can Cutter

Works great

Jason G Verified Purchase

Fc-2000 Oil Filter Can Cutter

I only used this cutter once since purchase and it works perfectly. I already knew this from working with tubing and pipe cutters, you don’t crank down on the knob to apply a lot of pressure initially on the cutter wheel. Just turn the knob a little bit and then spin the tool around the filter can and then turn the knob a little more after each spin around the can. Just let the cutter wheel do the work slowly.

This product works great. Sharp blade cuts filters open quickly. I put the filter into my bench vise, rotate the tool, the filter is open.

Worked great. Followed recommendation on youtube to use a vise to hold the oil filter and then tighten the cutter slowly in increments with a few rotations between each tightening.

Easy to use, cut the filter open in less than one minute.

Excellent!

This tool worked just as advertised. A very useful tool for quickly and cleanly cutting your oil filter apart for media inspection.

We bought FC-2000 (12-00923-1) oil filter cutter in your organisation. Order No:2456696 Invoice: 821748 Date 05.05.17 But didnt come Manufacturing certification with oil filter cutter. Could you send us Manufacturing Certification

Works great no issues. Used on Champion 108-1 series oil filter, a must have.

The cutter works great. The two Allen (Hex) key screws were difficult to loosen for the cutter wheel to slide and adjust to the filter diameter and cutting force. Once you get over this, the cutter is a charm.

Jimmy A Verified Purchase

Fc-2000 Oil Filter Can Cutter

I have three complaints against this product: The first is that, while it says it is made in the USA, the bearings on it very clearly say Made in China. As someone who likes to buy American as much as possible, this was slightly irritating as I was explicitly looking for an oil filter cutter made in the United States. The second complaint is that the washers that hold the slider on were upside down. As any aircraft mechanic worth her or his salt knows, the smooth side of the washer always goes away from the fastener head to prevent unnecessary wear on the surface its touching. The third complaint is that it just doesnt cut as well or as nicely as other oil filter cutters Ive used, and just doesnt feel very nice or work as well as I hoped a $97 oil filter cutter would. But, it still gets the job done and my complaints are pretty minor.