Model No. | Description | Part Number | Price | Buy |
---|---|---|---|---|
MC9862066-6 | MC9862066-6 Mixture Control | 05-00239 | $1276.00 | |
MC600-72 | Mixture Control Solid Wire MC600-72 | 05-01254 | $378.00 | |
MCC299507-0201 | McC299507-0201 Mixture Control | 05-00181 | $461.00 | |
MCC299507-0401 | McC299507-0401 Mixture Control | 05-00183 | $1402.00 | |
MCS1220-13 | MCS1220-13 Mixture Control | 05-00195 | $1353.00 | |
MCC299507-0301 | McC299507-0301 Mixture Control | 05-00182 | $1692.00 | |
MCC299508-0401 | McC299508-0401 Mixture Control | 05-00189 | $729.00 | |
MCC299508-0402 | McC299508-0402 Mixture Control | 05-00191 | $1105.00 | |
MCS1220-3 | MCS1220-3 Cessba Mixture Control | 05-00196 | $1094.00 | |
MCC299507-0101 | McC299507-0101 Mixture Control | 05-00179 | $476.00 | |
MC9862066-1 | MC9862066-1 Mixture Control | 05-00237 | $1477.00 | |
MCS1220-12A | MCS1220-12A Mixture Control | 05-00194 | $985.00 | |
MC9862066-5 | MC9862066-5 Mixture Control | 05-00238 | $1236.00 | |
MC565548041 | MC565-548-041 Mixture Control | 05-00993 | $713.00 | |
MCC565-548-042 | MC565-548-042 Mixture Control | 05-00994 | $1160.00 |
- Solid Metal Construction - Pilot Friendly Knobs - Lifetime Lubrication - Superior Low Friction Conduit - Custom Controls Available |
Mixture Control Solid Wire MC600-72
Perfect fit on my Cessna 150L after trimming to match old one. Makes a huge difference over the old stock non-vernier one. Now I can lean with some precision.
Mixture Control Solid Wire MC600-72
Perfect fit on my C150. Make sure you get some Clamps to secure the cable, other than that was fairly easy to install took about 2 hours. Looks factory and now I can finally fine tune my leaning.
Mixture Control Solid Wire MC600-72
Simple to install. Seems to be constructed with durable materials. Great product!
Mixture Control Solid Wire MC600-72
Good fit, easy to work with, improved from older cable
Mixture Control Solid Wire MC600-72
This is a very nice unit! Compared to the wimpy, cheapo control that Piper installed, it looks huge, like a pineapple, but once youve installed it, it doesnt seem that big, and it has great action. I installed this in a PA-22, just to the right of the throttle, which was replaced with a MCVA455-139 unit. The original cable routing, with two 90* bends wont work, so the cable arcs under the control column to its hole in the firewall. Youll have to cut one meter off the end of the Bowden cable: be sure to pull the control knob back about four inches before you cut it with a thin cut off wheel in a Dremel tool. Verify the hole in the mixture arm pivot shaft will accommodate the inner shafts diameter. Youll also have to use a drift to spread open the Bowden cable mount bracket, attached to the engine mount, a couple inches ahead of the firewall (have fun working around the cabin heat box). The chain on the control column rubs the cable with the wheels full aft, so I slit a 6 length of 3/8 soft aluminum tube and put it over the Bowden cable where the chain rubs and crimped it in place. Add inspecting this rub strip, annually, to your ICA and youre all set. Other than that, and using a step drill to bore out that gaping, 3/4diameter mounting hole in the instrument panel, its pretty straight forward. Its a bit awkward tightening the 3/4 nut behind the instrument panel, but just keep wiggling the control while tightening the nut and it will snug up securely. Every pilot who flies the old dame will appreciate it.
Mixture Control Solid Wire MC600-72
Mixture Control Solid Wire MC600-72
Mixture Control Solid Wire MC600-72
Please note, Aircraft Spruce Canada's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Canada assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Yes, these are vernier controls.
Yes, these documents can be supplied. Please request them at checkout.
MC9862066-6 (part # 05-00239) is the mixture control only.