PreKote© a simple procedure that replaces the use of traditional chromate conversion coatings and the need for acide etches, solvent washes and other toxic processes. Small aircraft shops have also used PreKote© to successfully replace the use of chromate conversion coating pens for smaller repair areas. By eliminating the need for these additional processes, paint preparation time and cost can be reduced by up to 40%. Approved for use by the Boeing Commercial Aerospace Group, Department of Defense and currently flying over 1,500 United States Air Force aircraft, PreKote© has proven consistent results with a variety of paints and primers. PreKote© can be used on a wide range of surfaces including aluminum, steel, magnesium, titanium, CRES, galvanized, composite and plastic surfaces. Environmental, Health & Safety Reason for Using PreKote PreKote© use also eliminates the need for forced air containment suits which are required by OSHA when using traditional chromate conversion coatings. Simply rain gear and goggles/face shield are all that is required. |
I believe this product to be everything it is advertised to be. I will definitely be using this product on future projects.
Non-Chromated Adhesion Promoter Prekote 1 Quart
Good stuff
Non-Chromated Adhesion Promoter Prekote 1 Quart
Easy to use, not harmful to the environment, the primer bonded very well. Whats not to like?
Non-Chromated Adhesion Promoter Prekote 1 Quart
Works as advertised, spray on, rinse off
Non-Chromated Adhesion Promoter Prekote 1 Quart
1 quart of Prekote came in a box with a sprayer that screws into the bottle. The sprayer didnt work. Price had almost doubled from that quoted in my 2-year old A.S. catalog. With the $20 shipping this stuff was about three times the original price. The Prekote was easy to use though, a lot easier than Alumiprep followed by Alodyne.
Non-Chromated Adhesion Promoter Prekote 1 Quart
Too early to tell. Job is complete and well see if it blisters/peels.
Non-Chromated Adhesion Promoter Prekote 1 Quart
Works as described- my first time using this product. It did an excellent job of prepping my aluminum boat for paint. My order arrived quickly, I will buy from Aircraft Spruce again.
Non-Chromated Adhesion Promoter Prekote 1 Quart
Used this on some ruddervators for a super vee that is being put back together. Looks like good adhesion to the old magnesium. Will see how they hold up.
Great Producct ! I couldnt believe how much oxidation came off the parts. I sprayed it on then scrubbed with maroon scotchbrite in two directions and rinsed it off. Very ECO friendly and safe to use. Forget the alodine etc. AKZO works amazingly well with this simple prep.
At a point in construction where gear legs needed to be primed/painted. Considered the old Alumiprep/Alodine, even went so far as to purchase alumiprep. But the idea of using Chromate did not appeal to me. Researched this and felt that this would be appropriate. The preparation was fairly easy. Had the legs painted at a local body shop and they came out very nicely. Will need to see how they last in the long run, but now very satisfied.
Please note, Aircraft Spruce Canada's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Canada assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
The volume of PreKote SP required to treat a given surface varies with the dispensing method. Higher volume dispensing systems (drum pumps) used for treating an entire aircraft will use one gallon of PreKote SP to treat 120–160 square feet. Low volume trigger spray bottles will yield 200–300 square feet per gallon of PreKote.
Per the PreKote web site, PreKote has been proven to be compatible with any epoxy or urethane primer, or top coat, from major manufacturers, and can be used on any part that will subsequently be primed.
The mfg @ for the quart size is 065-1002.
SHELF LIFE OPENED: 1 YEAR, UNOPENED: 3 YEARS
We have added the SDS to the Documents section of the web page.
You would use one or the other. Alodine is a different process.
Yes, PreKote may be used on magnesium.
No, it meets HMS15-1100.