FREE SHIPPING ON ORDERS OVER $699 (SOME EXCLUSIONS APPLY) | 877-795-2278

Avery Vise Grip Dimpler 3/32

$84.75/Each
Part# 12-00611
MFR Model# 550

Overview

Made for dimpling in restricted and hard to reach places where regular dimple dies won’t fit. Made with 7” VISE GRIP plier. Machined tool steel dimple dies are T.I.G. welded to the VISE GRIP jaws then polished. 2 sizes available (3/32” and 1/8”).

Reviews

These will dimple in tight spaces

Wendy S Verified Purchase

Avery Vise Grip Dimpler 3/32

January 26, 2024

Expensive but just the right tool when needed. Keep the spacer in the jaws.

Charles S Verified Purchase

Avery Vise Grip Dimpler 3/32

August 30, 2022

Works great for small areas

Luigi Verified Purchase

Avery Vise Grip Dimpler 3/32

March 8, 2022

These vice grip dimples are a must have for any aircraft builder

Matthew M Verified Purchase

Avery Vise Grip Dimpler 3/32

November 24, 2021

Onkar S Verified Purchase

Avery Vise Grip Dimpler 3/32

June 12, 2021

Arrived in two days UPS ground and in excellent condition. Worked as stated.

Kevin S
March 30, 2021

Good quality tool and works well for medium-small spaces. Isn’t quite the whole solution for a very tight space. I had to bend out the end of a rib to fit the tool in.

Irv
April 23, 2020

Q&A

Please note, Aircraft Spruce Canada's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Canada assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.

Q: Is the 1/8 inch dimpler for 1/8 inch countersink rivets?

Yes that is correct.

Q: How far into a sheet can the dimple vise grip extend to before bottoming out? (AKA how far into the sheet from the edge can a hole be located - and still be able to be dimpled?)

The dies are welded onto the Vise Grip jaws with about 1/2 of the die diameter extending out past the jaws. Measuring from the center of the dimple die you have about 1-1/8 to the back of the jaws. That should give you 1 to 1-1/8 reach from the edge of the material to the center of your hole to be dimpled.

Q: Does this dimple at 100 or 120 degrees?

This is 100 degree.

View in Catalog

View Image View in Catalog