One piece heat treated tool steel jig. Use for accurate & fast drilling of rivet holes for plate nuts. Has flexible handle design. Use for both on lug (both holes on 1 side) & two lug (holes on both sides) style nut plates - K1000 & K1100 style nutplates.
|
a great tool to use when mounting nut plates, very accurate
Two-Lug Plate Nut Drill Jig 10-32
Fast prompt delivery. As advertised
If youre installing many nut plates, these things are well worth it. Just drill the pilot hole and then use the jig to drill the rivet holes. No futzing with clamps, drill bits walking and misaligned holes. The tool part is made from hard carbon or spring steel so the drill will not wallow out the holes.
Please note, Aircraft Spruce Canada's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Canada assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
No. These will not work with the mini nut plates.
P/N# 12-03041 is for a 6-32 thread and 12-04790 is for a 6-28 thread.
The center pin is .163 inches.
These nut plate drill jigs have a spacing between the rivets of .688" (17.46mm) -- and the spacing between the rivet and the screw is .344" (8.73mm) (same on both sides of the screw). The # 1160 jig has a pilot pin for the screw hole and the pin diameter is .139" diameter (3.53mm)
We do not offer a drilling jig for a 4-40 sized anchor nut.