Description | Size | Part Number |
---|---|---|
Clamps, Plain AN742-D4 Aluminum | 1/4-Inch | AN742-D4 |
Plain loop-type line support clamps, made of aluminum alloy or steel meeting specification QQ-A-362, condition T. Heat-treated to a minimum tensile strength of 50,000 psi. |
just what we needed
Clamps, Plain AN742-D4 Alum
Economical, exactly as ordered
Clamps, Plain AN742-D4 Alum
Its a clamp, what mare can you say?
Using it to make an Aeronca landing gear snare cable. Its a good low cost part for that but not perfect since the tab is offset and not centered.
Please note, Aircraft Spruce Canada's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Canada assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
These have both been measured out to .219". You can use #10 sheet metal, or 10-32 threaded bolts or machine screws.
Dash 2 thru 10 has a .375" band width, and the larger dash numbers have a .500" band width.
This clamp will use a 10-32 threaded bolt.
1/32 INCH.