Pneumatic Riveter with Custom Machined Heads for use with Zenair blind rivets, sold separately
ZENAIR Riveting System ZENAIR blind (or pulled) rivets have been used to construct the all-metal Chris Heintz designs since the 1970s, and make riveting a quick and easy process! The ZENAIR riveting system forms the rivet head as the blind rivet is pulled, providing a low profile dome finish and high shear strength. Fast installation, simple tools and low cost make this a popular riveting system with homebuilders! Note: The riveter is supplied with the custom machined heads, required for the Zenair blind rivets, for use with Zenair blind rivets, sold separately. |
Glad I ordered two. One for A4 rivets, one for A5. Because the rivet head is not that quick to change out—takes some pressure to get it screwed back in. The gun works great and love the stem catcher.
Zenair Pneumatic Riveter
THIS IS SPECIAL FOR ZENAIR PLANES , GOOD
Zenair Pneumatic Riveter
Zenair Pneumatic Riveter
Bought this to replace the same worn out riveter. The old one was good for about 16,000 rivets. Pulling strength nearly 2,000 lbs. I am very pleased with its performance. The Zenith concave riveter head comes in 1/8 and 5/32 inch. The 3/32 and 3/16 are flat tips.
Zenair Pneumatic Riveter
Works great, as advertised..
Solidly built tool but not adjusted properly for the smaller rivets. Adjustable parts too tight to adjust with tools supplied(bent). Rivet stems would not eject without pliers.
Zenair Pneumatic Riveter
Please note, Aircraft Spruce Canada's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Canada assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
A 20 gallon is recommended.
This riveter is designed to be used with the Zenair specific 1/8" & 5/32" rivets. They are a special rivet, which look like countersunk rivets, but when pulled with this tool, they are round head. I could not find a countersunk rivet for this design rivet head. The rivet part #'s are 12-03709 & 12-03711.
Approx 3.25 lbs.
This is made in China.