Aircraft Spruce Canada
Brantford, ON Canada
Corona, CA | Peachtree City, GA
Chicago, IL | Wasilla, AK
Aircraft Spruce Canada- Wishlists
- 1-877-795-2278
- Contact Us
Contact Us
Call Us
Sign In
- Photo may represent series and not specific product
- SHARE
1015/1020 Bush 3/8 X.065 - 1 Foot
MFR Model#
- JUMP TO
- Overview
- Reviews
- Q&A
- View in Catalog
| O.D. (In.) | I.D. (In.) | Wall | Part No. |
|---|---|---|---|
| 3/8 | 1/4 | .065 | 03-16700-1 |
Overview
|
Seamless mechanical tubing may be used either statically or dynamically. Its close tolerance, good finish and dense structure make it ideal for parts such as shafts, bushings, bearings, etc. Tensile strength 80,000 PSI. Drill or ream for proper bolt fit. If manufacturing test reports are required, there is a minimum $15.00 charge per order. Please indicate in the special instructions box at the time of order that certs are required. |
Reviews
ID appeared to be a little small, but it reamed out just fine and welded in. OD was OK.
Verified Purchase
1015/1020 Bush 3/8 X.065 - 1 Foot
Verified Purchase
1015/1020 Bush 3/8 X.065 - 1 Foot
As ordered
Verified Purchase
1015/1020 Bush 3/8 X.065 - 1 Foot
Everything is on spot with your service. Shipping could be lowered some but other then that items are top quality!
High quality precise dimensions
Fast shipping and just what I needed thinks
I use this stuff all the time. Terrific bushing stock. Commons sizes and easy to ream to nice fit on the I.D.
The inside diameter of this stock material is about a tenth smaller than advertised. We had to ream the I/D before we could use it.
Verified Purchase
1015/1020 Bush 3/8 X.065 - 1 Foot
Q&A
Please note, Aircraft Spruce Canada's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Canada assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
It is 1020 steel.
The website is correct and we measured our stock. When doing the math you have to double the wall because you will lose .065 on both sides of the "ID."
