Bracket and hardware ONLY. Fits any skull cap spinner. |
Was nice to find this bracket at Aircraft Spruce, had been looking for some time
Bracket And Hardware For Skull Spinner
Bracket And Hardware For Skull Spinner
Perfect fit, well made item.
Bracket And Hardware For Skull Spinner
The bolt holes are 7/16 diameter without enough edge clearance to drill up to 1/2 so I could not use it on my Lycoming O-360 which uses 1/2 diameter bolts.
There needs to be more edge distance where the holes are drilled and I used a bit of JB Weld on the screw to prevent it from loosening.
Please note, Aircraft Spruce Canada's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Canada assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
It is a #10 sheet metal screw. Our part number is THB10X12.
Center hole to center hole is approx. 4-5/8". This is used with the 5" and 6" skull spinner caps.