Overview

Application

• Attaching the handles involves NO welding! Each handle has two, #10-32 threaded holes in the handle ends. Mounting is simple.
• 1. Simply drill a #10-32 clearance hole thru your roll bar (forward and aft sides).
• 2. Enlarge the aft side holes to a diameter of 5/16".
• 3. Shove the handles into the 5/16" holes until the handle ends butt up against the forward #10-32 clearance holes.
• 4. Install two, #10-32 screws.
• (You may even opt to countersink the #10-32 screw clearance holes to utilize flat head screws.
• If you use a standard bolt and are concerned with the appearance of the large head, you can even grind the head down flatter for a better look. These handles work great!)

Specifications

• The handles are made from light weight aluminum.
• They are a solid design for strength.
• They are 5/16" in diameter and measure 3-1/2" long.
• The center to center dimension is 4".
• The handle length was intentionally designed rather long.
• It is intended to extend thru a 1-1/2" to 2" diameter roll bar.
• If the handle it too long for your application, you may simply cut the length short, re-drill, & tap the handle ends.