A blend of solvents used for viscosity and drying control of Poly-Brush, Poly-Spray and Poly-Tone. Blend #R-65-75 is recommended as the standard reducer in normal weather, 65°75°F. #RR-8500 is a retarder-reducer with slower drying time. Recommended for temp above 85° & warm humid weather. Important Notice: All mixed paints are special order and are non-returnable. |
What can I say? Its a gallon of reducer.
Poly-Fiber R65-75 Reducer Gallon
Works like it should. I give you guys a lot of credit for you packing and shipping. Always packed very well and always get paint etc. in two days. Awesome
Poly-Fiber R65-75 Reducer Gallon
Keep the cap screwed down tight or it will evaporate away. Keep them in a dry place, too, as one wee rust spot and it will evaporate through that too.
Poly-Fiber R65-75 Reducer Gallon
Very good
Poly-Fiber R65-75 Reducer Gallon
Used about 10% more than called for with my hvlp turbine setup. Helped the flow and results were great.
Poly-Fiber R65-75 Reducer Gallon
Poly-Fiber R65-75 Reducer Gallon
Poly-Fiber R65-75 Reducer Gallon
i bought a taylorcraft envelpoe that didnt fit my aircraft. AS did nothing about it. Not happy
Poly-Fiber R65-75 Reducer Gallon
So far, so good! Needed the reducer to thin PolyBrush and that is still a couple weeks in the future. Not necessary this time, but thanx for the fast shipping. Just wish the reducer was not QUITE so $$$$$!!
Poly-Fiber R65-75 Reducer Gallon
Aircraft Spruce, you responded again, and very quickly I might add. Much appreciated. Thanks for being there when we need you the most. Even little things like this, that will hold up a project if not responded to quickly, are taken care of routinely by you folks!! That is why we will continue to use Aircraft Spruce!!
Please note, Aircraft Spruce Canada's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Canada assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
You would use a 3:1 Mix Ratio. 3 Poly Tone, 1 R65-75 Reducer.