Solvent used to remove coatings for repairs, for clean up, and to release cemented seams. |
Works as advertised, will purchase again when needed
Poly-Fiber Mek Quart
Great service
Poly-Fiber Mek Quart
Haven’t used anything yet but fast shipping
Poly-Fiber Mek Quart
Have yet to use product but shipping was very fast!
Poly-Fiber Mek Quart
A great product, but very unforgiving without goggles and good rubber gloves. I’m not sure about using the cheaper hardware brands. But this is PMA and we are talking about putting a sting chemical on your aircraft. Is peace of mind really outweighed by a few bucks cheaper? It probably shouldn’t be. This product does the job, but take eyewear and finger protection seriously. The fumes can be nasty, too.
Poly-Fiber Mek Quart
Poly-Fiber Mek Quart
The Poly Brush stuff is the best and I would use nothing else for an airplane. But I also use MEK to bond model railway track to tie strip and there is an adequate substitute for NON-AVIATION endeavors available at Crappy Tire for very cheap and no need for shipping costs.
always a good product
Received packaged well and undamaged.
Works great and is being used as we speak.
Poly-Fiber Mek Quart
Please note, Aircraft Spruce Canada's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Canada assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.