Lids were slightly loose on each container, so that the cans felt sticky.

Jerome P Verified Purchase

EZ Epoxy 1-1/2 Quart Kit

I like this epoxy, especially the low odor and well-behaved cure. BTW, you can use the convenient West pumps with EZ Poxy as follows. My measurements showed that the West large pump delivers about 0.66 fl. oz. of resin per full stroke. The 207/209 hardener pump delivers about 0.22 fl. oz. per full stroke mixing this with the resin squirt yields a total of about 0.88 fl. oz., with a resin to hardener volume ratio of about 2.95. The 205/206 pump delivers about 0.12 fl. oz. of hardener per full stroke mixing this with the resin squirt yields a total of about 0.78 fl. oz., with a resin to hardener volume ratio of about 5.45. The recommended EZ Poxy resin/hardener volume ratio is 100/47 = 2.13. Two strokes of the resin pump and three strokes of the hardener pump yields a mix ratio of 1.32/0.66= 2.00, which is close to the recommended 2.13. If you want to be closer to the recommended ratio, use 2.1 strokes of the resin pump to 3 strokes of the hardener pump, which yields a volume ratio of 1.39/0.66= 2.11.

Seems to be an excellent replacement for the old Saf-T-Poxy I used years ago.

Bill F Verified Purchase

EZ Epoxy 1-1/2 Quart Kit

This is a great prodcut!

Bobby B Verified Purchase

EZ Epoxy 1-1/2 Quart Kit

I was disappointed when the web stated it was out of stock, but I received the order a couple of days later anyway. EZ-84, now 83, IIRC, is what 95% of my Velocity is constructed with.

easy to use. Ive been using it in temperatures just over 90 degrees, the pot life is a little less than two hours at this temp but I still have lots of time to get everything laid up how I want to. The cure time at this temp is less than 24 hours.

Awesome product. works well on my aircraft project.

Awesome Epoxy for the Aircraft I am building. Have to know your amounts and weights.

Perfect for student projects.

Its the only product we use for students to complete their composite projects. Hardener just needs some heating during the winter.

I built my entire cozy IV using E-Z Poxy with EZ 83 hardner except for the fuel tanks I used the more fuel resistant slow hardner. It works great and is consistent plus it was always available to buy unlike some of the other systems.

E-Z POXY is the only resin I have used for Lay-Ups and structural work on my Velocity. I use the pump and have it set at 100-47. If the shop is at 70 degrees it will set up in 18-24 hours with the EZ 83 hardener. It is easy to mix by it’s self or add Micro Balloons, Flox or Milled Fiber to mixed resin. On big jobs I use a carbon mask to not take in the fumes. It is cut able with a knife at 18 hours sanding 24-36 hours. I find the when mixed with Milled Fiber you need to let set for 36 hours or the sanding paper plugs up. The use of a heat gun really get it flowing if needed. It starts to get thicker in about 30 minutes so heat with the gun and flow out. I really like working with the stuff.