A Safe "No-Slip-Grip" for your thru-bulkhead cables. This unit prevents your throttle mixture, choke or any push-pull cable from slipping at the firewall/ bulkhead location. Machined from lightweight aluminum. Installation is simple with a drill and wrench. Once installed, the cable is threaded and the end nut is snugged down on the cable casing for positive encapsulation. Designed specifically for the aircraft industry, these fittings can be installed on virtually any application that requires a solid hold on any cable assembly with a rigid outer case. Thousands of applications: auto, boat, race car, motorhome. Used with 1/4" thru 7/32" diameter cable. |
Absolutely required and works great with 3/16” throttle cables in conjunction with the cable safe no slip grip housing.
Cable Safe Adapter Housing 3/16
This works great to as a firewall penetration cable retaining device. Solved my cable slippage issue with this and the 3/16” adapter housing.
Cable Safe No Slip Grip
When using a 3/16 Bowden cable, this reducer does a good job of allowing the cable to be secured.
Cable Safe Adapter Housing 3/16
Useful but had to slightly open the interior hole to make it fit.
Cable Safe Adapter Housing 3/16
Just arrived and fit for purpose.
Cable Safe No Slip Grip
worked perfect to secure my 1/4 od mixture cable
Cable Safe No Slip Grip
Cable Safe No Slip Grip
These really work great, look good too.
works fine
This is a great addition to the firewall penetration to ensure a stable and safe connection for the cable. It is easy to install and is extremely lite. I recommend this for any cable pass through on the firewall!
Please note, Aircraft Spruce Canada's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Canada assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
05-16250 can be used with cable housing O.D. of 1/4" thru 7/32". If the housing O.D. is 3/16", spacer part number 05-16251 will be required to grip the housing.
The A930 or any cable with swaged threaded ends can not be used with the 05-16250 cable safe. Only cables with 1/4" O.D. outer housing, and a solid wire end can be used. A930, and other swaged threaded ends, will need to use part number 05-16252, which has two halves. The 05-16250 is a one piece unit and swaged ends will not allow it to be installed.
7/32 or 1/4" cable housing.
You will need to drill a 9/16" hole.
This will have a max panel thickness of .375".
This is a bulkhead fitting, slide the cables through and lock them in where you want. No cutting necessary.