Retaining washers are required for studs of -5 length or greater. Use split washer 2600- SW2 where it is desirable to have the stud fall away for minimum internal projection. Use internal tooth washer 2600-LW where it is desirable to retain the stud assembly rigidly. |
Worked as it should.
Camloc 2700/2600-Lw Retaining Washer
Not much to review. They fit and seem to hold the Camlock just fine. I used two sockets and extensions to install instead of the special tool.
Camloc 2700/2600-Lw Retaining Washer
Works
Camloc 2700/2600-Lw Retaining Washer
Best product I ordered.
Camloc 2700/2600-Lw Retaining Washer
These are a must if youre installing camlocs
Camloc 2700/2600-Lw Retaining Washer
Parts I need with Fast shipping
Camloc 2700/2600-Lw Retaining Washer
very well. meets the need
Camloc 2700/2600-Lw Retaining Washer
These clips hold the stud firm. Easy to install.
Camloc 2700/2600-Lw Retaining Washer
Spruce is dependable, helpful, and quick. These parts are exactly right. I have come to expect no less than perfect service from Spruce, and they have NEVER provided any less.
Arrived on time and worked just fine for my application.
Please note, Aircraft Spruce Canada's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Canada assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
No tool is available. A pair of needle nose pliers is commonly used to install these retainer washers on "T" end of the stud.